Hi Brian,
Brian Artigas wrote:
Hi All,
I just built a new VM running CentOS 5.4 with the latest stable
version of OpenSIPS from svn – I’m assuming 1.6.4-2. I copied my cfg
file that worked perfectly on another VM that was running 1.6.1 to the
new VM. I tweaked a few things: IP address, modules location, and
commented out all mi_datagram module lines, and since xlog is included
in the core, I commented out the loadmodule “xlog.so” line.
I’m now running into an issue where the xlog comments only work up to
about half way down the script. I can’t figure out for the life of me
why. Does anyone know why it would work for the top half of the script
but not the bottom half?
are you sure your script execution gets in the "lower half of your
script" ?? Maybe the changes you did when moving the script affected a
bit the script logic and it bails out in the "upper half" of the script,
on a different path.
For instance I have route 3 that handles invite requests. The first
half of the route handles incoming calls, the second half handles
outgoing calls. I get logging on all of the incoming calls, but none
of the outgoing calls. Again, aside from the tweaks mentioned above
this file is exactly the same as the one that works perfectly on
1.6.1. Any thoughts?
you can try in parallel (in the same spots) using xlog and log function
- log is a more basic function (does not accept vars to print), but just
to check if your script gets at that point.
Regards,
Bogdan
Thanks,
Brian
------------------------------------------------------------------------
_______________________________________________
Users mailing list
[email protected]
http://lists.opensips.org/cgi-bin/mailman/listinfo/users
--
Bogdan-Andrei Iancu
OpenSIPS eBootcamp - 28th February 2011
OpenSIPS solutions and "know-how"
_______________________________________________
Users mailing list
[email protected]
http://lists.opensips.org/cgi-bin/mailman/listinfo/users
