Almost sounds like you and I are having the same issue.
Here's my issue
http://opensips-open-sip-server.1449251.n2.nabble.com/Two-OpenSIPS-proxies-issue-td7580685.html
Do you have a SIP trace? I'm just wondering if we are having the same
problem. Does the ACK that gets relayed to ifself on the other IP have the
username missing in the RURI?
On , Jeff Pyle <[email protected]> wrote:
Hello,
I'm attempting to write a config to perform near-end NAT traversal on
Opensips 1.7. I'm having a problem with the loose_route of the ACK after
the 200 OK, and if I wait long enough, the BYE as well.
Here's the scenario. An INVITE comes in the WAN side and is t_relay'd to
the LAN side. The LAN-side UAS sends a 200 OK, and that is relayed back
to the WAN-side UAC. So far, so good. Then the WAN-side UAC sends the ACK
to the 200. Opensips relays this from its own WAN IP to its own LAN IP -
I found it with ngrep on the lo interface. Eventually Opensips sends a
408 back to the UAC.
Here's the relevant portion of the config, based largely on the included
sample. This works fine with single-interface configurations:
if (has_totag()) {
if (loose_route()) {
if (method=="INVITE") record_route();
if (!t_relay()) sl_reply_error();
exit;
} else {
if (method == "ACK") {
if (t_check_trans()) {
if (!t_relay()) sl_reply_error();
exit;
} else {
exit;
}
}
sl_send_reply("404", "Not Here");
}
exit;
}
I've verified with xlogs the ACK hits in the loose_route() portion of the
config. It does hit t_relay, but it relays the message to itself on
its 'other' IP. I've tried to look the extended debugs but I'm not
finding anything telling. Unfortunately I don't have any experience with
multiple interface configurations. I suspect it has something to do with
the double Via lines added, one from each interface. Perhaps it's not
detecting the second Via as its own? (Even if that were the case, I can't
explain why it's not responding to itself on the lo interface.)
I do have mhomed=1 enabled. Without it the initial invite doesn't arrive
at the LAN-side UAS.
I've experimented with check_via, aliases, etc. No effect. Any
suggestions on where to go from here?
- Jeff
_______________________________________________
Users mailing list
[email protected]
http://lists.opensips.org/cgi-bin/mailman/listinfo/users
