Hi ,
have you changed to twice?
This happens if you try to use uac_replace_to (or uac_replace_from) twice.
s
Il 19/06/2013 15.18, M.Khaled W Chehab ha scritto:
while i am using uac_replace_to in failover route branch i can find
that TO header is not changed(sip user part ) but appended an new raw
as I want it to be To: "971552448304" <sip: [email protected]>
SIP to address:
sip:[email protected]:[email protected]
SIP to address User Part: 835822971552448304
SIP to address Host Part: xx.xx.xx.55sip
SIP to address Host Port: [email protected]
<mailto:[email protected]>
please advice
regards
*From:*M.Khaled W Chehab [mailto:[email protected]]
*Sent:* Wednesday, June 19, 2013 2:41 PM
*To:* [email protected]
*Cc:* [email protected]
*Subject:* uac_replace_to problem
Hi,
I am running opensips 1.8.3 with do_routing module
A dial_rule prefix has 3 trunk gateways ( gw1,gw2,gw3)
After do_routing(,)
I am setting the $rU and fixing the To Tag header using
uac_replace_to( and the call go to gw1 with correct TO tag as I set it ,
but when calls fails on gw1 ,then I set the $rU in route[6] to go to
second in route and it goes with bad TO header, since it goes with the
same To header in the 1^st invite
That target gw1
1-how to fix the To header in the second invite to gw2
loadmodule "uac.so"
modparam("uac","restore_mode","auto")
uac_replace_to("$avp(dst)","sip:$var(prefix)$avp(dst)@$td
<sip:$var%28prefix%29$avp%28dst%29@$td>");
t_on_failure("1");
on failure_route[1] {
.
if (!t_check_status("487")) {
#xlog("------------route6-------\n");
$avp(failure_count) = $avp(failure_count) + 1; #480|486|603
route(6);
}
Route[6]{
.
.
.
$rU = $var(prefix) + $avp(dst);
uac_replace_to("sip:$var(prefix)$avp(dst)@$td
<sip:$var%28prefix%29$avp%28dst%29@$td>");
}
Regards
_______________________________________________
Users mailing list
[email protected]
http://lists.opensips.org/cgi-bin/mailman/listinfo/users
_______________________________________________
Users mailing list
[email protected]
http://lists.opensips.org/cgi-bin/mailman/listinfo/users
