You may want to look into using 3xx redirect responses to the UAC from OpenSIPS if the PBX requires the actual source IP address to be the UAC.
> On Nov 18, 2015, at 9:52 AM, Travis Manson-Drake <[email protected]> > wrote: > > Hello all, > > Is there any way I can have Opensips use the source IP of a UAC rather than > the source IP of itself when sending request’s to the applicable end points? > > I currently have something set up to where the there is a phone outside of my > network, it sends its request to the opensips proxy, which then sends the > request’s to the correct PBX. However, when opensips sends the request to the > PBX or to the phone it changes the source IP to the ip of itself. How would I > have opensips send the original source ip of the PBX or the phone rather than > sending its own source IP? I’ve tried using $avp variables that are assigned > a value of the source ip of the UAC or PBX, and then injecting them in my > routing logic. But I can’t seem to find a way to just tell opensips “this is > the $si you need to use when sending out these request’s” > > Als,o after various xlog statement’s it looks like it maintains its source ip > throughout the logic, just when it goes to send the request out it then > changes the $si to its own ip address. > > Thank you guys for your time! > > Travis Manson-Drake > Voice Systems Analyst L1 > Simply Bits, LLC > Now You’re Thinkin’ Smart! > 5225 N. Sabino Canyon Road > Tucson, AZ 85750 > Phone: 520-545-0311 > Fax: 520-545-7252 > Support Hotline: 5205450333 > www.simplybits.com <http://www.simplybits.com/> > > _______________________________________________ > Users mailing list > [email protected] <mailto:[email protected]> > http://lists.opensips.org/cgi-bin/mailman/listinfo/users > <http://lists.opensips.org/cgi-bin/mailman/listinfo/users>
_______________________________________________ Users mailing list [email protected] http://lists.opensips.org/cgi-bin/mailman/listinfo/users
