Hi Paolo, I put the values into the configure and all looks well, not a single error. much appreciated, thank you.
./configure MPIF90=mpif90 CC=gcc F90=gfortran F77=gfortran make all 2>&1 | tee makeall.log regards, nick - Linux Administrator > -----Original Message----- > From: giannozz at democritos.it > Sent: Wed, 10 Nov 2010 08:35:50 +0100 > To: pw_forum at pwscf.org > Subject: Re: [Pw_forum] QE: install problem, 4.2.1 > > > On Nov 10, 2010, at 4:31 , ac.rain at inbox.com wrote: > >> the following I put in there > > you shouldn't put there anything: configure will do the job > >> and it seemed to compile most things. >> >> MPIF90 = mpif90 >> F90 = gfortran >> CC = gcc >> F77 = gfortran >> >> the "make all" output looks good now except for some output lines >> that say "make[2]: g: Command not found". > > so it doesn't look good > >> So then I added a specification for "LD = ld" in the make.sys and >> it seemed to break it > > you shouldn't add anything to make.sys > > P. > --- > Paolo Giannozzi, Dept of Chemistry&Physics, Univ. Udine > via delle Scienze 208, 33100 Udine, Italy > Phone +39-0432-558216, fax +39-0432-558222 > > > > > _______________________________________________ > Pw_forum mailing list > Pw_forum at pwscf.org > http://www.democritos.it/mailman/listinfo/pw_forum ____________________________________________________________ Send any screenshot to your friends in seconds... Works in all emails, instant messengers, blogs, forums and social networks. TRY IM TOOLPACK at http://www.imtoolpack.com/default.aspx?rc=if2 for FREE
