On Thu, May 28, 2015 at 7:22 AM, [email protected] <[email protected]> wrote: > I was using mpich2 to run parallel version of pw.x and ph.x. I think this > error information was generated by my mpich2. In this case, where could I > reach the real error information?
you have to talk to the people that operate the machine that you are running on. i have seen this kind of termination most often when people submitted a calculation to a batch system without reserving a suitable amount of wall time and then the calculation was forcibly terminated by the batch system. you should see that in the batch system outputs that correspond to your calculation, if that is what happened to you. axel. > > Best Regards, > Dr. Yin Li > Department of Biophysics,Medical School, University of Pecs, > No.12 Szigeti Street, Pecs, H-7624, HUNGARY > Phone: +36-72-535271/36271 > > _______________________________________________ > Pw_forum mailing list > [email protected] > http://pwscf.org/mailman/listinfo/pw_forum -- Dr. Axel Kohlmeyer [email protected] http://goo.gl/1wk0 College of Science & Technology, Temple University, Philadelphia PA, USA International Centre for Theoretical Physics, Trieste. Italy. _______________________________________________ Pw_forum mailing list [email protected] http://pwscf.org/mailman/listinfo/pw_forum
