Dear Oliviero, Thank you and I am sorry that I forgot to attach the output file. Here it is and it definitely missed the Environ subsection. I have also check the result folder of example01 after calling run_example.sh. Both files missed the Environ subsection.
I have Intel parallel studio 2015 installed and I have my ./config pointing to icc ifort mkl etc. I have also followed the Environ installation instructions. May I know how to check if the installation went wrong? Thanks, Rolly PhD, Research Fellow, Department of Physics and Materials Science, City University of Hong Kong Tel: +852 3442 4000 Fax: +852 3442 0538 From: [email protected] [mailto:[email protected]] On Behalf Of Oliviero Andreussi Sent: Thursday, September 15, 2016 8:40 PM To: PWSCF Forum Subject: Re: [Pw_forum] Running Environ with pw.x Dear Rolly Ng, I am not sure about your question, are you concerned that no output specific of Environ is produced by your calculation? You say this because you confronted the output you have with the reference reported in the Environ/example/example01/references directory? You say that you attached the output, but I can only see the input files, from which I notice that you are running a calculation in which basically all the environment effects are turned off (environ_type = vacuum). Still, you should see some rather minor modifications in the output of pw due to Environ, in particular a summary of environ input parameters at the beginning (introduced by "Environ Module”) and a line at each SCF step saying "add environment contribution to local potential” (while as a matter of fact no contribution is added if environ_type = vacuum, thus no contribution is reported in the following output). If you don’t see any of this things in your output, probably the compilation of QE + Environ had some problems or you are not using the right executable, since the input and the command seem ok and Environ 0.2 is fully compatible with QE 5.3.0. If you want to forward me the output or if you have other doubts or questions, don’t hesitate to ask the forum or to contact me directly. Best, Oliviero Andreussi -- Senior Postdoctoral Researcher École Polytechnique Fédérale de Lausanne (EPFL) and Università della Svizzera Italiana (USI) of Lugano USI Campus, Via G. Buffi 17, 6904 Lugano, Switzerland Emails: oliviero.andreussi @ epfl.ch -or- usi.ch Tel: +41-(0)58-666-4810 / Skype: olivieroandreussi Web: https://sites.google.com/site/olivieroandreussi On 14 Sep 2016, at 17:48, Rolly Ng <[email protected]> wrote: Dear Environ users, I have compile Environ 0.2 with QE v.5.3.0 and I am trying to run example01 using my own input format, so I extract the essential parts from the run_example.sh as h2o.in and environ.in. These 2 input files are placed in the same directory. Then I called mpirun -np 24 ./pw.x --environ -inp h2o.in |tee h2o.out, I can see the output file is being generated but I cannot see any subsection stating Environ in the output file as attached. Did it run with Environ plugin enabled? Is QE v.5.3.0 supported? Thanks for your advise. Regards, Rolly Ng -- PhD. Research Fellow, Dept. of Physics & Materials Science, City University of Hong Kong Tel: +852 3442 4000 Fax: +852 3442 0538 <environ.in><h2o.in>_______________________________________________ Pw_forum mailing list [email protected] http://pwscf.org/mailman/listinfo/pw_forum
h2o.out
Description: Binary data
h2o_water.out
Description: Binary data
_______________________________________________ Pw_forum mailing list [email protected] http://pwscf.org/mailman/listinfo/pw_forum
