On 02/09/2018 05:54 PM, Dan Prince wrote: > HI James, > > Not for an "overcloud" I think. But you could check out some of the > work we did in Pike, Queens, and now Rocky for the new containerized > undercloud. See the upstream docs here: > > https://docs.openstack.org/tripleo-docs/latest/install/containers_deployment/undercloud.html > > There are two ways to approach it: > > One is 'undercloud deploy' which is an experimental interface that > lets you interact with the heat templates to drive a single node > installation much like you would when creating an Overcloud. > > The second approach which we are actively building is a command which > will consume the same undercloud.conf that instack-undercloud uses to > drive the same installer framework that 'undercloud deploy' provides. > > Quickstart has some playbooks that can drive 'undercloud_deploy'... > but I think we are switching it over to 'undercloud install' > exclusively. So if either one suits your needs you might be able to > get quickstart to do this all for you on a single node as well. > > We've got lots of ideas on how to improve the single node use case in > the future BTW. Hoping to prototype some things at the upcoming PTG in > Dublin.
I haven't been able to do any level of quickstart build now. I actually went all the way back to the cheatsheet I had made for myself when I was working with Pike on RHEL 7.4, a sheet which gave me the steps to successfully build a quickstart, single-system install. Using those exact steps, the setup kicks me off the system about a minute into the setup. This is with RHEL 7.4, 7.5 against Pike as well as Queens. I am at a loss now, seeing as I can't even duplicate a setup that worked for me in December. _______________________________________________ users mailing list [email protected] http://lists.rdoproject.org/mailman/listinfo/users To unsubscribe: [email protected]
