Hi Stephen, I set up an IPv6-in-IPv4 test case with virtual IPv6 addresses and this scenario does not work indeed:
http://www.strongswan.org/uml/20120620-0806/ipv6/rw-ip6-in-ip4-ikev2/ On the gateway side we get Jun 20 08:06:50 moon charon: 01[ENC] parsed IKE_AUTH request 1 [ IDi CERT .. CP(ADDR) .. ] .. 01[IKE] peer requested virtual IP %any 01[CFG] assigning new lease to '[email protected]' 01[IKE] assigning virtual IP fec3::1 to peer '[email protected]' 01[IKE] traffic selectors fec1::/16 === 0.0.0.0/0 inacceptable Regards Andreas On 06/19/2012 08:48 PM, Pisano, Stephen G (Stephen) wrote: > Hi: > > How can I control the virtual IP version (i.e., v4 vs. v6) requested > when using ‘leftsourceip=%config’? > > I am assuming that the code looks at the IP version of the outer tunnel > address and requests the same version type (just my guess), but the > specific use case of interest is IPv6 traffic within an IPv4 tunnel. > > Is it possible to request a IPv6 address when the tunnel in IPv4? > > Thanks, > Stephen ====================================================================== Andreas Steffen [email protected] strongSwan - the Linux VPN Solution! www.strongswan.org Institute for Internet Technologies and Applications University of Applied Sciences Rapperswil CH-8640 Rapperswil (Switzerland) ===========================================================[ITA-HSR]== _______________________________________________ Users mailing list [email protected] https://lists.strongswan.org/mailman/listinfo/users
