Hi Andreas, Our system was typically built with minimum logs. During debugging I can manually turn up log levels, but during boot I will have to rebuild the whole system and I probably won't get to that until next week. Also our IPsec system is under a monitor program, and I just found the monitor was restarting the system and that probably explains the "ipsec start" output as it was shutting down. I only heard about the initial start issues, and not sure if the monitor restaredt the system by mistake, or if the restart was due to a real issue. I'll report back if I can gather more info from experiments or from other folks worked on the system. And I'll get the logs if the issue is not resolved next week.
Thanks, Terry On Wed, Jul 11, 2012 at 10:24 PM, Andreas Steffen <[email protected]> wrote: > Hi Terry, > > could you send a log of your connection setup? > > Regards > > Andreas > > On 07/11/2012 10:41 PM, T Cheung wrote: >> Hi, >> >> I have a net2net connection. On the very first time one host starts up, and >> tries a connection, the host that starts up seems to show incorrect >> status info. Output from "ipsec status" shows only the "ESTABLISHED" >> line, but no "INSTALLED, TUNNEL, ESP" or the "<net> ==== <net>" >> line. "ipsec status" on the other host has all 3 lines. Is this a known >> issue? Is this fixable? >> >> Thanks, >> Terry > > ====================================================================== > Andreas Steffen [email protected] > strongSwan - the Linux VPN Solution! www.strongswan.org > Institute for Internet Technologies and Applications > University of Applied Sciences Rapperswil > CH-8640 Rapperswil (Switzerland) > ===========================================================[ITA-HSR]== > > _______________________________________________ Users mailing list [email protected] https://lists.strongswan.org/mailman/listinfo/users
