--On Wednesday, September 10, 2014 12:09:52 PM +0200 Miroslav Kubiczek
<[email protected]> wrote:
--On Wednesday, September 10, 2014 11:31:07 AM +0200 Martin Willi
<[email protected]> wrote:
I had the following working config which nevertheless prompts for
username and password on the device (iPhone):
The whole point of XAuth authentication is to verify a
username/password combination. You may disable XAuth if you don't
want that. Not sure if that can be configured in the iPhone UI,
though.
AFAIK this isn't possible. But you could use
rightauth2=xauth-noauth
for this connection so any combination of username/password would be
accepted.
Thanks for all suggestions! I tried xauth-noauth and got this error:
15[CFG] no XAuth method found for 'noauth'
So I assume I have to rebuild with: --enable-xauth-noauth configure
option?
yes. And you have to use a version of strongswan newer than 5.0.2
because the option was introduced in 5.0.3.
_______________________________________________
Users mailing list
[email protected]
https://lists.strongswan.org/mailman/listinfo/users
