The client gets ip from a standard virtual pool in strongswan and then i setup trafficmanagement etc running the script. In certain cases I want to nat the clients given adress to the framed-ip. A usecase is eg. the framed-ip will be the source address for any number of ips assigned from the virtual pool.
eg. the client connect with two devices which again are assigned two different ips from the virtual pool, but the source address will always be the framed ip for both. On Mon, Aug 24, 2015 at 6:50 PM, Andreas Steffen < [email protected]> wrote: > Hi Roger, > > how is this going to work if the client does not install the framed-ip? > > Regards > > Andreas > > > On 24.08.2015 17:44, Roger Skjetlein wrote: > >> Hi, >> >> the current setup uses eap-radius and we do have framed ip set for some >> clients due to traffic management and policies. >> >> The question is if it's possible to get or use the framed-ip from radius >> in the updown script without assigning the ip to the client? >> >> Regards, >> >> >> _______________________________________________ >> Users mailing list >> [email protected] >> https://lists.strongswan.org/mailman/listinfo/users >> >> > -- > ====================================================================== > Andreas Steffen [email protected] > strongSwan - the Open Source VPN Solution! www.strongswan.org > Institute for Internet Technologies and Applications > University of Applied Sciences Rapperswil > CH-8640 Rapperswil (Switzerland) > ===========================================================[ITA-HSR]== > > -- "Over vidden flyger renen; efter den i vind og væde! - Bedre det, end bryde stenen op af fattig jord dernede!"
_______________________________________________ Users mailing list [email protected] https://lists.strongswan.org/mailman/listinfo/users
