Hello Everyone, I'm trying to set up a tunnel between Strongswan and Cisco 2811. I'm following instructions per:
https://www.cisco.com/c/en/us/support/docs/ip/internet-key-exchange-ike/117258-config-l2l.html Phase 1 parameters are configured in ipsec.conf as: keyexchange=ikev1 ike=aes128-md5-modp1536 When I try starting up the tunnel, the IKE proposal sent out contains: Per log on Cisco router: *Dec 12 21:32:39.438: ISAKMP: encryption AES-CBC *Dec 12 21:32:39.438: ISAKMP: keylength of 128 *Dec 12 21:32:39.438: ISAKMP: hash SHA256 *Dec 12 21:32:39.438: ISAKMP: unknown DH group 31 *Dec 12 21:32:39.438: ISAKMP: auth pre-share *Dec 12 21:32:39.438: ISAKMP: life type in seconds *Dec 12 21:32:39.438: ISAKMP: life duration (basic) of 1520 I've captured the packet in wireshark and the packet indicates the wrong DH group and wrong hash. I've attached the captured pcap file. My ipsec.conf file is as follows: config setup charondebug=ike 4 #####IS5##### conn m1 type=tunnel authby=secret auto=add keyexchange=ikev1 ike=aes128-md5-modp1536 esp=aes128-sha1 ikelifetime=1520 right=80.0.0.3 rightid=80.0.0.3 rightsubnet=10.10.3.0/24 left=80.0.0.2 leftid=80.0.0.2 leftsubnet=192.168.0.0/16 I've tried changing to 3DES and SHA512 and different DH groups in ipsec.conf. All the same, I always see AES-SHA256-DHGRP31 going out. Any opinions or suggestions to correct my ipsec.conf would be highly appreciated. With rgds, Makarand.
ipsec.pcap
Description: ipsec.pcap
