Try to force a new build. If it doesn't work, restart your Continuum.
Emmanuel
Jonathan Tilley a écrit :
Hi,
I have a build that has completed in failure, but Continuum still thinks
that the build is running.
The tail of the build logs is
[surefire] Tests run: 1, Failures: 0, Errors: 0, Time elapsed: 0 sec
[INFO] ------------------------------------------------------------------------
[ERROR] BUILD ERROR
[INFO] ------------------------------------------------------------------------
[INFO] There are test failures.
[INFO] ------------------------------------------------------------------------
[INFO] For more information, run Maven with the -e switch
[INFO] ------------------------------------------------------------------------
[INFO] Total time: 4 minutes 49 seconds
[INFO] Finished at: Thu Jun 08 15:04:55 BST 2006
[INFO] Final Memory: 27M/63M
[INFO] ------------------------------------------------------------------------
errorcode after mvn clean install is ...
1
starting postExec...
But Continuum doesn’t recognise that the build has completed
The build results says
Start Time Jun 8, 2006 3:00:04 PM
End Time Duration Started since : 17 h 48 min 41 sec
Build Trigger Scheduled State BuildingBuild#
My question is how can one manually kill a build or tell Continuum that the
build
has completed.
Cheers
Jonathan
This transmission is confidential and intended solely for the person or
organisation to whom it is addressed. It may contain privileged and
confidential information. If you are not the intended recipient, you
should not copy, distribute or take any action in reliance on it. If you
have received this transmission in error, please notify the sender
immediately. Any opinions or advice contained in this e-mail are those
of the individual sender except where they are stated to be the views of
RDF Group plc. All messages passing through this gateway are virus scanned.
