Actually I have 2 listeners running on different ports. One for SSL traffic and other one for non-SSL traffic. I have enabled the wireshark logging of both the ports today and will get the data by end of day. It was my assumption that since the data was not properly readable it could be due to SSL not decrypting the data properly, but I might be wrong. The wireshark output should make things much clear.
Thanks, Rajiv -----Original Message----- From: Emmanuel Lécharny [mailto:[email protected]] Sent: Monday, September 10, 2012 3:51 PM To: [email protected] Subject: Re: SSLFilter not working properly Le 9/10/12 10:24 AM, Rajiv Kasera a écrit : > Hi, > > > > I have enabled SSLFilter in my Mina implementation (2.0.4) and it > seems that the filter is not working properly. Some of the data > packets received in the Decoder is not as per the correct format and > hence the connection terminates. Below are the hexdump of the bytes > which are common in all such failure cases. > > > > HEXDUMP of initial few bytes - 16030100C9010000C5030150 > > > > Is there any known issue in SSLFilter? The issue comes up in low and > high load situation. Any help in this regard will be highly appreciated. I would assume that your application is working well without the SSLFilter. Otherwise, yes, the SSL Filter is working properly. The question is : are you using it properly ? We need more than just the few bytes you pushed. Can you provide a full wireshark dump ? -- Regards, Cordialement, Emmanuel Lécharny www.iktek.com
