No I am not using any wildcards in blacklist filter of MINA. All the IP Addresses are IPV4 type and are individual IPs. Could you pls give me some leads on your statement "You could build your own string and pattern based blacklist filter for IPV6" so that I can try it.
Thanks And Regards, Nitin Phuria -----Original Message----- From: Jon V. [mailto:[email protected]] Sent: Saturday, July 27, 2013 12:27 AM To: [email protected]; [email protected] Subject: Re: Does MINA 2.0.4 supports IPV6 Are you using wildcards in the blacklist filter? You could build your own string and pattern based blacklist filter for IPV6 in under 30 minutes. On Fri, Jul 26, 2013 at 3:10 AM, Nitin Phuria <[email protected]>wrote: > The issue is registered in JIRA see the below link. > https://issues.apache.org/jira/browse/DIRMINA-957 > > Thanks And Regards, > Nitin Phuria > > -----Original Message----- > From: Emmanuel Lécharny [mailto:[email protected]] > Sent: Thursday, July 25, 2013 6:49 PM > To: [email protected] > Subject: Re: Does MINA 2.0.4 supports IPV6 > > Le 7/25/13 1:47 PM, Nitin Phuria a écrit : > > Hello All, > > > > MINA build in BlacklistFilter does not support IPV6 address. If MINA > itself > > supports binding to IPV4 and IPV6 why this restriction was kept in > > BlacklistFilter. > > That's a different problem... > > > > I checked the org.apache.mina.filter.firewall.Subnet class > > in MINA sources and found that it specifically checks for Inet4Address > > > > if (!(subnet instanceof Inet4Address)) > > { > > throw new IllegalArgumentException("Only IPv4 supported"); > > } > > > > We are using this filter and now supports only IPV4 > > > > Pls advice. > > Please fill a JIRA, we are going to look at it. > > ATM, I suggest you remove this check from the code, and see if it works > for you. If so, we could then patch MINA, this is probably the fastest > way to solve your issue. > > > -- > Regards, > Cordialement, > Emmanuel Lécharny > www.iktek.com > > >
