Hello Simon, thank you very much for his hint. I really could have thought about looking for any other value of resource position! I will give it a try! Hope, that BODY_ONLOAD will not ask for the ResponseWriter...
Regards, CAK -- Carsten Kaiser Principal Consultant mailto:[EMAIL PROTECTED] Mobile: +49 (0)170 5270206 Valtech GmbH Werner-Heisenberg-Straße 2 63263 Neu-Isenburg Germany Phone: +49 (0)6102 88468-0 Fax: +49 (0)6102 88468-28 http://www.valtech.de Geschäftsführer: Ingo Kriescher Amtsgericht Düsseldorf HRB48672 -----Ursprüngliche Nachricht----- Von: Simon Kitching [mailto:[EMAIL PROTECTED] Gesendet: Mittwoch, 28. März 2007 05:31 An: MyFaces Discussion Betreff: Re: How to add inline javascript in application phase? Mike Kienenberger wrote: > On 3/27/07, Carsten Kaiser <[EMAIL PROTECTED]> wrote: >> But I'm still interested in getting some statement concerning the >> description on the Wiki page referenced above. > > Edit it :-) I think Carsten is asking for an explanation of the example code. After looking at it, I'm not sure why Carsten was getting the original exception re no response-writer. I hadn't read the code carefully enough and was assuming that AddResource.addJavascriptInline was writing it out immediately. However the method takes a "ResourcePosition" parameter of value HEAD_BEGIN, and is simply adding that inline script to a set of values to output later. So I'm not sure why the response stream would be needed then. By the way, Carsten, the resource position can also be BODY_ONLOAD which is what you stated you wanted.. Regards, Simon
