Hello;
There are many places where a dimension must be set, such as margins, tab stops, indents, line spacing, grid spacing, etc. But OO only provides two decimal places. This is very limiting. A simple dimension of .125" or .375" cannot be specified, ending up as .13" and .38" respectively. Forget about a sixteenth of an inch (.0625"), since it requires four decimal places. The only way to achieve higher precision is to change to millimeters or points, which are much smaller units of measurement to begin with, so two decimal places can describe a much smaller increment. But the user should be able to work in his or her preferred unit of measurement.
I would like to see as many as six decimal places. It can't be all that hard to add this capability. Thank you.
Good thinking! This is really necessary for people who can count beyond 10:-) I'll certainly vote for any issue addressing this requirement.
Peter HB
--------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
