On Fri, 2005-08-12 at 18:14 -0400, David Rudel wrote: > I have a curious problem, and i was wondering if it is a bug or if there is > something extra I need to do. It is more a nuisance than a major problem. > I often have two Calc documents open at once. One document has a list of > important information, which I can then cut and paste where needed in the > other document. > I have noticed that when I switch from one document to the other and click > on a cell, the outline normally does not appear. I can still do the cut and > paste, but the cells I select do not shadow as I select them, so I have to > be careful to make sure I am dragging my cursor over the correct cells. > Is this a known issue? Is there something specific I have to do to tell > Calc that I really want it to consider the other document the active page? > [I searched the knowledge base, but I was unable to find anything related.]
Hi David, If I understand you correctly, there should have been something about this in the knowledgebase. It appears you are looking at the two different levels of selection within Calc, right? That is, you can have a selected cell(s), or you can activate a cell, in which case you are typing contents etc. Is that what you are describing? Regards Jonathon -- OOo Tips (RSS) - http://mindmeld.cybersite.com.au/tips.rss OOo Knowledgebase - http://mindmeld.cybersite.com.au/ Cybersite Consulting - http://www.cybersite.com.au/ Training4Linux - http://www.training4linux.com --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
