Hi! Thanks for the help.... there is a line i entered in the monit control
file that looks something like this:
/var/run/openser.pid..... when i run openser from /etc/init.d/openser
start, and look at the web interface of monit, i see that openser failed to
start and and when i look into the /var/run directory, there is no pid for
openser. does that mean openser was not running at all? Also, please let me
know if there is any other way other than monit to run openser which is
installed from CVS. I want to directly run openser without the monit daemon.
I could not find any logs relevant to openser.
Thanks again for the help,
----- Original Message -----
From: "Bogdan-Andrei Iancu" <[EMAIL PROTECTED]>
To: "Padmaja RV" <[EMAIL PROTECTED]>
Cc: <[email protected]>
Sent: Tuesday, May 30, 2006 2:08 PM
Subject: Re: how to run openser through monit daemon?
may openser fails to start due a configuration error - check the log for
potential errors and hints.
regards,
bogdan
Padmaja RV wrote:
Hi!
Thank you for the mail.
I have already followed all the steps mentioned in the links .
http://openser.org/dokuwiki/doku.php?id=install_and_maintain_openser_from_cvs
http://openser.org/dokuwiki/doku.php?id=make_openser.init_script_work
... pls see my previous mail below.... after all these steps when i
actually want to run openser from /etc/init.d/openser start command, it
starts monit daemon and then the command prompt appears back..... when i
go to the directory /var/run/ i cant see the openser.pid file and also
the monit daemon after a while responds that it could nt start openser.
this i can see at http://localhost:2812 where the web interface for the
monit is running...........
Please let me know the problem free and preferred source of running
openser.... which is the best way to run openser (is it from binary or
cvs)?
Thanks and Regards,
Padmaja
----- Original Message ----- From: "Bogdan-Andrei Iancu"
<[EMAIL PROTECTED]>
To: "Padmaja RV" <[EMAIL PROTECTED]>
Cc: <[email protected]>
Sent: Tuesday, May 30, 2006 1:20 PM
Subject: Re: [Users] how to run openser through monit daemon?
Hi,
See
http://openser.org/dokuwiki/doku.php?id=make_openser.init_script_work
regards,
bogdan
Padmaja RV wrote:
Hi all!
I have installed openser through CVS from the following link
http://openser.org/dokuwiki/doku.php?id=install_and_maintain_openser_from_cvs
till the 8 th step in the link everything went well fine. in the 9 th
step, there is a link to make oepnser.init script work and i did all
the steps as described. I downloaded and installed the monit daemon to
start openser thru it. however, now if i type /etc/init.d/openser
start, it says command monit to start openser and then the command
prompt appears back. i dont see the tcp and udp ports (5060 ) and other
information etc when the openser is started.....and i cant figure out
if it is running at all.....if i issue ps command, i dont see any pid
for openser.....if i open the web interface of the monit daemon, i see
that it is trying to start the openser but after some time it shows
failed to start......
please let me know what to do asap.....
Thanks
_______________________________________________
Users mailing list
[email protected]
http://openser.org/cgi-bin/mailman/listinfo/users
