Hello,
Thanks, i tried this way.
avp_load_radius("callee");
if (is_avp_set("$avp(s:callee_routeid[0])")) {
if (avp_check("$avp(s:callee_routeid[0])", "eq/i:0")) {
route(0);
} else if (avp_check("$avp(s:callee_routeid[0])", "eq/i:1")) {
route(1);
}
}
Is it possible, that radius set an array of routeid,
And try to use them in order, when first failed, the second etc?
is there a way, to somehow pop the first item of the array?
pop the first item, call route with this value,
pop again set to t_on_failure() as argument
on failure_route pop again and set the next avp to t_on_failure
Is it possible, or i'm dreaming? :9
Regards,
Tamas
Klaus Darilion wrote:
I think
if (avp_check("$avp(i:20)","eq/i:0/)) {
route(13);
exit;
} else ...
should work. check the syntax of avp_check
regards
klaus
Cseke Tamas wrote:
Hello,
I'm using openser 1.1.0
I'd like to make a dinamic routing, the plan is radius set an avp,
which contains the routeid,
but my config is bad, and i don't know what can be the problem
route($avp(i:20)); don't work so i tryied this way:
switch($avp(i:20)) {
case 0:
route(0);
break;
case 1:
route(1);
break;
case 2:
route(2);
break;
}
but this is bad too, can anybody give me an advice?
the problem is in the line "switch($avp(i:20)) {" i guess,
but switch can accept pseudo vars, so i don't kow what the problem
caould be?
Thanks any help,
Tamas
_______________________________________________
Users mailing list
[email protected]
http://openser.org/cgi-bin/mailman/listinfo/users
--
Cseke Tamás, fejlesztő
www.eworldcom.hu
1027 Budapest, Csalogány u. 23-33
Tel.: +36 1 999-7400
Fax: +36 1 999-7401
Jelen üzenet és az összes hozzá csatolt állomány bizalmas. Kérjük
kezelje bizalmasan, és ne adja tovább harmadik fél részére és ne
készítsen róla másolatot. Amennyiben Ön nem a levél címzettje
kérjük jelezze az eWorld Com számára és törölje a levelet a
számítógépéről.
_______________________________________________
Users mailing list
[email protected]
http://openser.org/cgi-bin/mailman/listinfo/users
