Hello,
Markus Hardiyanto wrote:
Hello,
I'm new in openvz. yesterday I'm succeeded installing openvz on centos 4.4 and
can make openvz run. my question is how to make partition inside the VE? when i
execute this commands:
# vzctl enter 101
# entered into VE 101
# df -h
Filesystem Size Used Avail Use% Mounted on
simfs 1.0G 95M 930M 10% /
you see there is only one partition /, how can i make /boot, /, /home, /tmp
partition separately inside the VE?
I don't quite understand what do you want? =) In order to mount some
filesystem on any directory in VE just use usual mount. However the list
of filesystems, that you can use in VE is limited (look at
/proc/filesystems in VE, sysfs and nfs can be added via `vzctl set
<veid> --features` command).
Every real fs is deployed on some device. Usually VE doesn't use such
devices (like /dev/sda1, ...). But you can give VE an access to the
device via `vzctl set <veid> --devnodes`. Note, that this is the same
device, that is on your host node: some partion on your HN for example,
so deleting files from it will remove files from the host.
next question is how to make the VE accessible from the internet? while i
already supply a public IP for the VE:
# vzctl set 101 --ipadd xxx.xxx.xxx.xxx --save
but when i try to ping it from my laptop, it can't be reached. i do can ping
the physical node. what should i configure?
i saw in the wiki about creating NAT, but that is for private IP while in my
case i want to use public IP for my VEs. please advise.
check, that /proc/sys/net/ipv4/ip_forwarding contents "1"
thanks
Best Regards,
Markus
Send instant messages to your online friends http://uk.messenger.yahoo.com
_______________________________________________
Users mailing list
[email protected]
https://openvz.org/mailman/listinfo/users
_______________________________________________
Users mailing list
[email protected]
https://openvz.org/mailman/listinfo/users
