Hello,
few weeks ago I was trying to setup IPv6, but that doesn't work.
http://forum.openvz.org/index.php?t=msg&goto=12809&&srch=IPv6#msg_12809
I would really like to have this feature. So I'm trying to experiment
with veth devices, but not much success again :(
My host node has IPv6 support:
staj-dev:~# ifconfig
eth0 Link encap:Ethernet HWaddr 00:13:72:1B:0B:97
inet addr:195.113.233.4 Bcast:195.113.233.255 Mask:255.255.255.0
inet6 addr: 2001:718:1:e::23:3004/64 Scope:Global
inet6 addr: fe80::213:72ff:fe1b:b97/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2136 errors:0 dropped:0 overruns:0 frame:0
TX packets:1304 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:211656 (206.6 KiB) TX bytes:138480 (135.2 KiB)
Interrupt:17
It is accessible on IPv6:
> [EMAIL PROTECTED]:~$ ping6 -c1 2001:718:1:e::23:3004
> PING 2001:718:1:e::23:3004(2001:718:1:e::23:3004) 56 data bytes
> 64 bytes from 2001:718:1:e::23:3004: icmp_seq=0 ttl=63 time=0.129 ms
I setup IPv4 part this way:
> staj-dev:~# ifconfig veth012.0 0
> staj-dev:~# echo 1 > /proc/sys/net/ipv4/conf/veth012.0/forwarding
> staj-dev:~# echo 1 > /proc/sys/net/ipv4/conf/veth012.0/proxy_arp
> staj-dev:~# echo 1 > /proc/sys/net/ipv4/conf/eth0/forwarding
> staj-dev:~# echo 1 > /proc/sys/net/ipv4/conf/eth0/proxy_arp
> staj-dev:~# ip route add 195.113.233.012 dev veth012.0
and it works:
> semik:~$ping -c1 195.113.233.12
> PING 195.113.233.12 (195.113.233.12): 56 data bytes
> 64 bytes from 195.113.233.12: icmp_seq=0 ttl=61 time=0.252 ms
I'm trying to follow
http://wiki.openvz.org/Virtual_Ethernet_device#Virtual_ethernet_device_with_IPv6
but after executing (2nd, 3rd) lines
> staj-dev:~# echo 1 > /proc/sys/net/ipv6/conf/veth012.0/forwarding
> staj-dev:~# echo 1 > /proc/sys/net/ipv6/conf/eth0/forwarding
> staj-dev:~# echo 1 > /proc/sys/net/ipv6/conf/all/forwarding
host node stop responding to ping6. I'm stuck here... I also do not want
run router advertisement daemon (if that is possible). My VE should have
address 2001:718:1:e::23:3012.
Inside VE I setup:
[EMAIL PROTECTED]:~# ifconfig
eth0 Link encap:Ethernet HWaddr 00:0C:29:63:A6:73
inet addr:195.113.233.12 Bcast:195.113.233.255 Mask:255.255.255.0
inet6 addr: 2001:718:1:e::23:3012/64 Scope:Global
inet6 addr: fe80::20c:29ff:fe63:a673/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:88 errors:0 dropped:0 overruns:0 frame:0
TX packets:88 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:7012 (6.8 KiB) TX bytes:6948 (6.7 KiB)
[EMAIL PROTECTED]:~# cat /etc/network/interfaces
auto lo
iface lo inet loopback
auto eth0
iface eth0 inet static
address 195.113.233.12
netmask 255.255.255.0
network 195.113.233.0
broadcast 195.113.233.255
gateway 195.113.233.4
dns-nameservers 195.113.144.233 195.113.144.194
dns-search cesnet.cz
eth0 inet6 static
iface eth0 inet6 static
address 2001:718:1:e::23:3012
netmask 64
veth interface is configured this way:
NETIF="ifname=eth0,mac=00:0C:29:63:A6:73,host_ifname=veth012.0,host_mac=00:0C:29:63:A6:74"
inside VE I see reasonable routes:
[EMAIL PROTECTED]:~# route -6
Kernel IPv6 routing table
Destination Next Hop
Flags Metric Ref Use Iface
::1/128 :: U 0 1 1 lo
2001:718:1:e::23:3004/128 2001:718:1:e::23:3004 UC 0 49 0 eth0
2001:718:1:e::23:3012/128 :: U 0 142 1 lo
2001:718:1:e::/64 :: U 256 0 0 eth0
fe80::20c:29ff:fe63:a673/128 :: U 0 0 1 lo
fe80::/64 :: U 256 0 0 eth0
ff02::16/128 ff02::16 UC 0 5 0 eth0
ff00::/8 :: U 256 0 0 eth0
but I'm not able even to ping to my host:
[EMAIL PROTECTED]:~# ping6 2001:718:1:e::23:3004
PING 2001:718:1:e::23:3004(2001:718:1:e::23:3004) 56 data bytes
From 2001:718:1:e::23:3012 icmp_seq=1 Destination unreachable: Address
unreachable
it is very interesting, that host node see my ping requests:
staj-dev:~# tcpdump -i veth012.0
tcpdump: WARNING: veth012.0: no IPv4 address assigned
tcpdump: verbose output suppressed, use -v or -vv for full protocol decode
listening on veth012.0, link-type EN10MB (Ethernet), capture size 96 bytes
18:48:53.301938 IP6 2001:718:1:e::23:3012 > ff02::1:ff23:3004: ICMP6, neighbor
solicitation, who has staj-dev6.cesnet.cz, length 32
18:48:54.301800 IP6 2001:718:1:e::23:3012 > ff02::1:ff23:3004: ICMP6, neighbor
solicitation, who has staj-dev6.cesnet.cz, length 32
18:48:55.302659 IP6 2001:718:1:e::23:3012 > ff02::1:ff23:3004: ICMP6, neighbor
solicitation, who has staj-dev6.cesnet.cz, length 32
but do not respond to ping :(
I'm trying this on 2.6.18-028stab035 system with vzctl version 3.0.16-5dso1.
Could anybody help? Thanks.
--
-----------------------
Jan Tomasek aka Semik
http://www.tomasek.cz/
_______________________________________________
Users mailing list
[email protected]
https://openvz.org/mailman/listinfo/users
