Sorry... sent for error before finishing..
BTW: after removing ip information from ifcfg-eth0 I still have to manually
run
ip route add default via 192.168.122.1
Now ifcfg-eth0 contains only
DEVICE=eth0
ONBOOT=yes
HWADDR=52:54:00:b0:6c:5f
BRIDGE=ovirtmgmt
NM_CONTROLLED=no
IPV6INIT=no
IPV4_FAILURE_FATAL=no
UUID=09d17057-618e-464a-b38c-e16ab0d72f75
systemctl list-units gives:
sys-devices-virtual-net-\
x3bvdsmdummy\x3b.device loaded active plugged
/sys/devices/virtual/net/;vdsmdummy;
sys-devices-virtual-net-bond0.device loaded active
plugged /sys/devices/virtual/net/bond0
sys-devices-virtual-net-bond4.device loaded active
plugged /sys/devices/virtual/net/bond4
sys-devices-virtual-net-ovirtmgmt.device loaded active
plugged /sys/devices/virtual/net/ovirtmgmt
sys-module-configfs.device loaded active
plugged /sys/module/configfs
sys-subsystem-net-devices-\x3bvdsmdummy\x3b.device loaded active
plugged /sys/subsystem/net/devices/;vdsmdummy;
sys-subsystem-net-devices-bond0.device loaded active
plugged /sys/subsystem/net/devices/bond0
sys-subsystem-net-devices-bond4.device loaded active
plugged /sys/subsystem/net/devices/bond4
sys-subsystem-net-devices-eth0.device loaded active
plugged Virtio network device
sys-subsystem-net-devices-ovirtmgmt.device loaded active
plugged /sys/subsystem/net/devices/ovirtmgmt
# ip addr list
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast master
ovirtmgmt state UP qlen 1000
link/ether 52:54:00:b0:6c:5f brd ff:ff:ff:ff:ff:ff
inet6 fe80::5054:ff:feb0:6c5f/64 scope link
valid_lft forever preferred_lft forever
3: ovirtmgmt: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue
state UP
link/ether 52:54:00:b0:6c:5f brd ff:ff:ff:ff:ff:ff
inet 192.168.122.160/24 brd 192.168.122.255 scope global ovirtmgmt
inet6 fe80::5054:ff:feb0:6c5f/64 scope link
valid_lft forever preferred_lft forever
5: ;vdsmdummy;: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN
link/ether f2:96:78:d1:69:74 brd ff:ff:ff:ff:ff:ff
6: bond0: <NO-CARRIER,BROADCAST,MULTICAST,MASTER,UP> mtu 1500 qdisc noqueue
state DOWN
link/ether 00:00:00:00:00:00 brd ff:ff:ff:ff:ff:ff
7: bond4: <NO-CARRIER,BROADCAST,MULTICAST,MASTER,UP> mtu 1500 qdisc noqueue
state DOWN
link/ether 00:00:00:00:00:00 brd ff:ff:ff:ff:ff:ff
# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)
Bonding Mode: load balancing (round-robin)
MII Status: down
MII Polling Interval (ms): 0
Up Delay (ms): 0
Down Delay (ms): 0
[root@f18aio network-scripts]# cat /proc/net/bonding/bond4
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)
Bonding Mode: load balancing (round-robin)
MII Status: down
MII Polling Interval (ms): 0
Up Delay (ms): 0
Down Delay (ms): 0
Don't know from where the bond0 and bond4 arrives and the ;vdsmdummy too..
and their configuration files...
Gianluca
_______________________________________________
Users mailing list
Users@ovirt.org
http://lists.ovirt.org/mailman/listinfo/users
