I could see that the volume (vol1) was mounted with nfs type. I dismounted the volume and mounted it again in both nodes but using glusterfs type.
This time, I could create a 10GB preallocated virtual disk. The events tab showed: 2013-Feb-19, 09:12:39 Add-Disk operation of 'vm1_Disk1' was initiated on VM vm1 by admin@internal. 2013-Feb-19, 09:30:35 The disk 'vm1_Disk1' was successfully added to VM vm1. Too slow, isn't? but worked El 19/02/2013 08:21 a.m., Fernando Ariel Martinez escribió: > I have installed ovirt 3.1 according to the instructions in "Integrating > Gluster storage into oVirt" - by Robert Middleswarth, linked in > http://wiki.ovirt.org/Documentation. > I was able to complete the instructions successfully but I have problems > when a need to create a VM. Especifically when I need to allocate space > for the virtual disk. > > I have: > 1 ovirt engine server, (admin) > 2 nodes, IBM System x 3650M3 (nodo1, nodo2) > 1 switch cisco SG 300-20 (to connect them) > > I created a VM (vm1). > When I add a 10GB preallocated disk to vm1, after a few seconds the > ovirt engine server loses the connection with the node SPM. > I can see in the events tab "Invalid status on Data Center Default. > Setting status to Non-Responsive." > Then, the SPM changes to the other node. At last, in the events tab I > can see "Operation Add-Disk failed to complete on VM vm1." > > I have set SELinux in permissive mode. I have also disabled iptables. > In the ovirt engine server there are an ISO domain, called iso, (NFS > Export Path: admin.cluster:/nfs/iso) and an Export domain, called exp, > (NFS Export Path: admin.cluster:/nfs/export). > In each node with gluster, the /data directory is used to create the > volume vol1 (type: Replicate) > The Data domain is called vms (NFS Export Path: localhost:/vol1). > > Some help wil be appreciated > > Fernando M. _______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users