Hi Dan, I first tried this without setting miimode, but then miimode pull was set to 0ms (oVirt engine 3.2.1) (via /proc/net/bonding/bond[n])
This was the reason why I added miimode=100 setting to custom bonding option in oVirt. As this is a very common setting, I would suggest to make it default for oVirt too ? Cheers, Sven. Sven Knohsalla | System Administration | Netbiscuits Office +49 631 68036 433 | Fax +49 631 68036 111 |E-Mail s.knohsa...@netbiscuits.com | Skype: netbiscuits.admin Netbiscuits GmbH | Europaallee 10 | 67657 | GERMANY -----Ursprüngliche Nachricht----- Von: Dan Kenigsberg [mailto:dan...@redhat.com] Gesendet: Mittwoch, 26. Juni 2013 09:04 An: Sven Knohsalla; Lior Vernia Cc: users@ovirt.org Betreff: Re: [Users] FW: ovirt 3.2.1 custom bonding options On Wed, Jun 26, 2013 at 01:56:09AM -0400, Sven Knohsalla wrote: > Hi, > > for all oVirt users who wants to run their nodes in balance-rr mode: > Go to "Network Interfaces" > --> "Setup Host Networks" > > Edit the bond interface you want to change > --> "Bonding mode"--> "Custom:" > --> "Custom mode" --> mode=0 miimon=100 (depends on your scenario) Is there any reason not to include miimon=100 within the predefined "Mode 0" selection? I believe that Engine should. _______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users