Am Montag, den 28.10.2013, 07:42 -0700 schrieb David Li: > > Hi Fabian, > > Yes rootpwd worked too! Thanks. > > Two new problems: > > But I found there is no networking for the stateless node. > What kernel boot options are used to either use DHCP or statically configure > the IP address for an interface on the node? > > I also need to have the sshd enabled. Is there a kernel option for that?
Hey David, here you can find all the supported boot params in ovirt node: http://gerrit.ovirt.org/gitweb?p=ovirt-node.git;a=blob;f=scripts/ovirt-init-functions.sh.in;h=c4280caefb89c77afc1e8bec8c925aa7f3039733;hb=HEAD#l214 Greetings fabian > David > > > > ----- Original Message ----- > > From: Fabian Deutsch <[email protected]> > > To: David Li <[email protected]> > > Cc: "[email protected]" <[email protected]> > > Sent: Friday, October 25, 2013 9:10 AM > > Subject: Re: [Users] How to pxeboot ovrit node into memory automatically? > > > > Am Freitag, den 25.10.2013, 08:57 -0700 schrieb David Li: > >> Hi Fabian, > >> > >> That kernel option worked for me! The node is booted up in RAM. Thanks! > >> > >> My next question is: > >> How do I specify the root login and passwd as boot parameters? > > > > Hey David. > > > > Nice that it worked! Were you able to register to the Engine? > > > > You can use the adminpw= and rootpw= kernel arguments to set passwords. > > use > > $ openssl passwd -salt 42 > > to create one or two passwords > > > > Greetings > > fabian > > > >> David > >> > >> > >> > >> > >> ----- Original Message ----- > >> > From: Fabian Deutsch <[email protected]> > >> > To: David Li <[email protected]> > >> > Cc: "[email protected]" <[email protected]> > >> > Sent: Thursday, October 24, 2013 11:47 PM > >> > Subject: Re: [Users] How to pxeboot ovrit node into memory > > automatically? > >> > > >> > Am Donnerstag, den 24.10.2013, 16:26 -0700 schrieb David Li: > >> >> Hi, > >> >> > >> >> I was following the instructions at > > http://www.ovirt.org/Node_PXE. My goal > >> > is to use pxeboot (iPXE) to boot the node entirely into RAM with > > rootfs. What I > >> > got now is an installation screen which requires a local storage. My > > system has > >> > no disk and this doesn't quite work for me. > >> >> > >> >> What's are the kernel parameters I need to use to boot the > > node into > >> > RAM automatically? I am OK as the first step with a stateless node. > >> > > >> > Hey David, > >> > > >> > the stateless mode is currently not completely working with oVirt > >> > Engine. That means a Node needs to be approved each time it boots into > >> > the stateless mode. > >> > The stateless mode can be entered by appending stateless to the > > default > >> > kernel arguments. > >> > > >> > Greetings > >> > fabian > >> > > > _______________________________________________ Users mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/users
