> ----- Original Message ----- > From: "Bob Doolittle" <[email protected]> > Sent: Wednesday, December 11, 2013 2:32:48 PM > > On 12/11/2013 02:12 PM, Einav Cohen wrote: > >> NFSv4: requires no firewall configuration (although I thought oVirt > >> handled this automatically - did you change your firewall config after > >> host-deploy?) > > did I change my firewall config on my Host, you mean (i.e. the storage > > client)? > > I thought that it didn't matter (i.e. only storage *server* firewall proper > > configuration is important)? > > No, I meant the storage server. In my case I use my Node as the storage > server, so host-deploy would configure the firewall for me. If you're > using a separate storage server it will require manual configuration. > Just as a sanity-check I'd probably try disabling the firewall > temporarily on your storage server, and see if it starts working with > v3. If not it's clearly something else.
Hi Bob, I disabled the firewall on my storage server and attempted to add another storage domain on the same storage server with v3 - it succeeded. to further verify - I then enabled the firewall again and attempted to add yet another storage domain with v3 - and it failed, just like before. so it seems that you are right - something is probably wrong with the firewall configuration on my storage server - I will investigate. Many Thanks! > > There could be other issues which v4 addresses which could cause issues > with v3 - firewall is just the one I've run into :). As long as you're > not concerned about non-root-partition exports you're probably fine > as-is (although I thought v4 support was still experimental? If not, why > isn't it the default?). > > Cheers, > Bob > > _______________________________________________ > Users mailing list > [email protected] > http://lists.ovirt.org/mailman/listinfo/users > > > _______________________________________________ Users mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/users
