Yup - mine's behind NAT too. Just install squid proxy and port forward the 3128 port through your firewall you should be all good. I believe with 3.4 you can now set the spiceproxy in the UI at cluster level.
Here's a quick snippet from my notes: yum install squid nano /etc/squid/squid.conf # http_access deny CONNECT !SSL_ports http_access deny CONNECT !Safe_ports acl spice_servers dst 172.16.0.0/24 http_access allow spice_servers service squid restart chkconfig squid on iptables -A INPUT -p tcp --dport 3128 -j ACCEPT engine-config -s SpiceProxyDefault=http://public_ip_address:3128/ service ovirt-engine restart On Fri, Feb 7, 2014 at 3:37 PM, Alan Murrell <[email protected]> wrote: > I have setup a test All-In-One install but it is behind a Linux NAT > firewall (IPTables). I have been reading about Spice-Proxy and know the > basics of setting it up (install squid, configure the ovirt engine > SpiceProxyDefault), however I just wanted to know how I would do this in > a NAT situation? Would I install Squid on the firewall? When I > configure SpiceProxyDefault on the ovirt-engine, I set it to use the > internal IP of the firewall/Squid? Anything else I would possibly need > to do? > > -Alan > _______________________________________________ > Users mailing list > [email protected] > http://lists.ovirt.org/mailman/listinfo/users >
_______________________________________________ Users mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/users
