Dan, Thanks for the information. I'll follow that RFE. Being able to re-provision a host and not have to remember the correct network interface mapping for 10 interfaces would be a huge help...too much can go wrong if I have to re-setup a config that I thought was saved in the engine.
Thanks, - Trey On Mon, Jun 22, 2015 at 3:35 AM, Dan Kenigsberg <dan...@redhat.com> wrote: > On Sat, Jun 20, 2015 at 12:28:10PM -0500, Trey Dockendorf wrote: > > I recently found that when I reinstall a VDSM host via the engine > > interface, if that host was actually re-provisioned via kickstart, the > > network settings defined in the engine are lost. Before the re-install I > > had defined 4 bonds and attached 5 logical networks to the host. After a > > re-install only ovirtmgmt was attached to the node. Is it intended > > behavior that a host's network configuration in the ovirt-engine be lost > > when a host is re-provisioned ? If I have to re-deploy a node, is there > a > > way to make the ovirt-engine define networks for that host get applied to > > the re-deployed system? > > Yes, this is the inteded behavior, though some consider this a design > bug. Network config is persisted on each host, and Engine do not > automatically applies its own definitions ona re-provisioned host, > however, we have > > 1194297 [RFE] Allow to synchronize all networks on an > out-of-sync host > > in the works, which would make life easier in such conditions. > > Dan. >
_______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users