On Tue, Aug 4, 2015 at 3:39 PM, Neil <[email protected]> wrote: > Sorry to be replying to my own post, but I'm not sure if by adding the Host > manually that I've perhaps messed up something now?
hosted-engine-setup was indeed doing something more on the HA side. I suggest to clean-up and try again, manually configuring it will requires more time. > How do I go about adding my default NFS storage domain because no storage > domain exists currently despite my hosted_engine being a VM already running > on my default domain? In fact when I look at my hosted_engine and go to > disks it shows there is no disk at all. It's attended: on oVirt 3.5 the hosted-engine storage domain (and also the engine VM by the way) are not directly managed by the engine. You have to add an additional Storage Domain for other VMs. > Thanks! > > Regards. > > Neil Wilson. > > > > On Tue, Aug 4, 2015 at 3:27 PM, Neil <[email protected]> wrote: >> >> Hi guys, >> >> I've gone through the oVirt admin front end as a test and I see I've been >> able to add the host to the Default datacenter manually. Not sure if perhaps >> this worked manually because it used root and I specified the password >> perhaps instead? >> >> Would be interesting to find out why this failed the automatic addition >> though. >> >> Thank you! >> >> Regards. >> >> Neil Wilson. >> >> >> >> >> On Tue, Aug 4, 2015 at 3:24 PM, Neil <[email protected]> wrote: >>> >>> Hi guys, >>> >>> I initially installed an AllinOne oVirt installation, but realised half >>> way through that I actually need a self-hosted-engine instead, so I did an >>> engine-cleanup and removed the database etc then ran... >>> >>> yum install ovirt-hosted-engine-setup >>> hosted-engine --deploy >>> >>> I installed Centos 6.4 minimal on the VM then did a full yum update to >>> 6.6 and restarted as well as disabled selinux. >>> >>> Everything went through perfectly and my engine is up and running, >>> however my installation suddenly terminated when trying to add the host to >>> the Default datacenter as follows.... >>> >>> [ INFO ] Engine replied: DB Up!Welcome to Health Status! >>> Enter the name of the cluster to which you want to add the host >>> (Default) [Default]: >>> [ ERROR ] Cannot automatically add the host to cluster Default: Cannot >>> add Host. Connecting to host via SSH has failed, verify that the host is >>> reachable (IP address, routable address etc.) You may refer to the >>> engine.log file for further details. >>> [ ERROR ] Failed to execute stage 'Closing up': Cannot add the host to >>> cluster Default >>> [ INFO ] Stage: Clean up >>> [ INFO ] Generating answer file >>> '/var/lib/ovirt-hosted-engine-setup/answers/answers-20150804143614.conf' >>> [ INFO ] Stage: Pre-termination >>> [ INFO ] Stage: Termination >>> >>> I've attached my engine.log and my answer file. I have confirmed that >>> both systems are able to reach each other, so I'm not sure if it's perhaps >>> some kind of DNS related issue perhaps? Note that I'm only using host file >>> resolution and not internal DNS names. >>> >>> Please could someone take a look and see if you are able to pick up >>> anything obvious please. >>> >>> Thank you! >>> >>> Regards. >>> >>> Neil Wilson. >>> >>> >> > > > _______________________________________________ > Users mailing list > [email protected] > http://lists.ovirt.org/mailman/listinfo/users > _______________________________________________ Users mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/users
