No it is not safe to only use two nodes as you can end up with split brain.
So two nodes and an arbiter node is needed. The arbiter doesn't need to be
that fancy.
Also the installer if installed with gluster as hosted storage (storage for
the engine) will complain if replica is less than 3.
/Johan
On December 15, 2017 12:54:14 PM Jarek <[email protected]> wrote:
Yes, I checked it but it seems I still need three nodes - 2 for storage and
one smaller for arbiter.
Is it safe to deploy it only on two nodes?
Am I wrong?
From: "Sandro Bonazzola" <[email protected]>
To: "Jaroslaw Augustynowicz" <[email protected]>
Cc: "users" <[email protected]>
Sent: Friday, December 15, 2017 12:03:24 PM
Subject: Re: [ovirt-users] Two node configuration.
2017-12-15 8:55 GMT+01:00 Jarek < [ mailto:[email protected] |
[email protected] ] > :
Hello, currently I'm using kvms with pcs&drbd on vms... is there any ovirt
solution for ha with two nodes (storage on local disks) without pcs& drbd
for storage? I know about gluster storage but it needs third host;/
Did you check [
https://access.redhat.com/documentation/en-us/red_hat_gluster_storage/3.3/html/administration_guide/creating_arbitrated_replicated_volumes
|
https://access.redhat.com/documentation/en-us/red_hat_gluster_storage/3.3/html/administration_guide/creating_arbitrated_replicated_volumes
] ?
BQ_BEGIN
_______________________________________________
Users mailing list
[ mailto:[email protected] | [email protected] ]
[ http://lists.ovirt.org/mailman/listinfo/users |
http://lists.ovirt.org/mailman/listinfo/users ]
BQ_END
--
SANDRO BONAZZOLA
ASSOCIATE MANAGER, SOFTWARE ENGINEERING, EMEA ENG VIRTUALIZATION R&D
[ https://www.redhat.com/ | Red Hat EMEA ]
[ https://red.ht/sig ]
[ https://redhat.com/trusted | TRIED. TESTED. TRUSTED. ]
----------
_______________________________________________
Users mailing list
[email protected]
http://lists.ovirt.org/mailman/listinfo/users
_______________________________________________
Users mailing list
[email protected]
http://lists.ovirt.org/mailman/listinfo/users
