Thanks, Fred. I have been looking at FCoE VDSM Hooks to no help. Looking at it again, I am still not able to see any FCoE [root@ovirtengine ~]# engine-config -g UserDefinedNetworkCustomPropertiesUserDefinedNetworkCustomProperties: version: 3.6UserDefinedNetworkCustomProperties: version: 4.0UserDefinedNetworkCustomProperties: fcoe=^((enable|dcb|auto_vlan)=(yes|no),?)*$ version: 4.1UserDefinedNetworkCustomProperties: fcoe=^((enable|dcb|auto_vlan)=(yes|no),?)*$ version: 4.2 I finally managed to find the "custom Property" where I could set "enable=yes,dcb=no" for fcoe, but when applying the change, I get unexepected error. Yes, the host was in local maintenance mode when I applied the change. I am afraid I am not understanding all the steps needed from the Virtual Connect configuration in the blade rack to the network interfaces inside oVirt. Should I add a new FCoE only network interface and should this have VLAN/IP address in a special range compared to the internal network in the rack? Thanks again.
From: Fred Rolland [mailto:[email protected]] Sent: 13. januar 2018 14:21 To: Luca 'remix_tj' Lorenzetto Cc: Gunder Johansen; users Subject: Re: [ovirt-users] Configuration of FCoE in oVirt 4.2 on HP BladeSystem c7000 Take a look also at the FCoE Vdsm hook: oVirt/vdsm | | | | | | | | | | | oVirt/vdsm vdsm - This is a mirror for http://gerrit.ovirt.org, for issues use http://bugzilla.redhat.com | | | |
_______________________________________________ Users mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/users
