On Wed, Jun 12, 2019 at 10:38 PM Dirk Rydvan <[email protected]> wrote: > > Hello, > > in a home lab with only one puplic IPv4-Adress is the Port 443 a very > precious one. > The installation of oVirt 4.3 on a single node/host with bare metal installed > CentOS works well. (oVirt Cockpit and local installed engine added after > installation of Centos 7.6). > > But it is more difficult to change the port from 443 to maybe 4443 the save > the port 443. > The change in: > - /etc/httpd/conf/conf.d/ssl.conf > - /var/lib/ovirt-engine/jboss_runtime/config/ovirt-engine.xml > and > - disable selinux > - add 4443 to public with firewall-cmd > > It does not work... now I see is more difficult than I think before... > A port redirection at the edge route from <public-IPv4>:4443 to > <private-IPv4>:443 does also not work, because the links points all to the > standard https adress without a port number. > Is there a way to change the default port 443 of oVirt engine to a other port?
I do not think this was ever tested, but you can try doing that by running engine-setup with an answer file that includes e.g.: OVESETUP_CONFIG/httpPort=int:2080 OVESETUP_CONFIG/httpsPort=int:2443 It should configure everything correctly, more-or-less. I guess most people in your position use some proxy, though, or ssh tunneling, etc. Good luck and best regards, -- Didi _______________________________________________ Users mailing list -- [email protected] To unsubscribe send an email to [email protected] Privacy Statement: https://www.ovirt.org/site/privacy-policy/ oVirt Code of Conduct: https://www.ovirt.org/community/about/community-guidelines/ List Archives: https://lists.ovirt.org/archives/list/[email protected]/message/2N3NYRZEOW7S5RK4QXOMDNQSB2YCFAWR/
