My Question was on format , if for amqp value we have <source=*> that means it can have both BINARY and LIST kind data type .
then why we needed DATA and AMQP SEQUENCE . Regards, Rakesh On Thu, Aug 1, 2013 at 6:54 PM, Rob Godfrey <rob.j.godf...@gmail.com> wrote: > Yes indeed Gordon, thank you for clarifying > > -- Rob > > > On 1 August 2013 15:01, Gordon Sim <g...@redhat.com> wrote: > > > On 08/01/2013 01:52 PM, Rob Godfrey wrote: > > > >> Data and AmqpSequence allow the sender to start sending data without > >> knowing how many bytes / values the data is going to consist of. This > >> allows for streaming scenarios where the size of the data is not known > up > >> front. > >> > >> Note also that there is no bound to the size of Data or AmqpSequence, > >> whereas an AmqpValue will always be bounded by the largest AMQP data > type > >> - > >> i.e. 4Gb (not that I would ever recommend sending a single message of > >> greater than 4Gb). > >> > > > > Just to clarify, each individual section of type Data or AmqpSequence is > > bounded and has its size encoded upfront. The ability to stream and/or > send > > unbounded amounts of data comes through sending multiple such sections in > > the same message. Right? (Whereas only a single AmqpValue section is > > allowed per message). > > > > > > ------------------------------**------------------------------**--------- > > To unsubscribe, e-mail: users-unsubscribe@qpid.apache.**org< > users-unsubscr...@qpid.apache.org> > > For additional commands, e-mail: users-h...@qpid.apache.org > > > > >
