Hej Parul,
I don't know the xbee shiel you are using, but with the ones I have
tried, I needed to connect the 5V of the shield to the Arduinos 5V to
get it to work...
Cheers,
Hauke
On 19.12.2015 09:44, Parul Agrawal wrote:
Hi Riot Users,
I need small help in running Xbee over Arduino due with RIOT. I tried
the test program which is located in RIOT/tests/driver_xbee with the
Makefile having XBEE_UART ?= "1".
I assume that with the above changes Xbee will be running over pin 10
and 11 of Arduino due(which is USART port) as per below configuration
mentioned in RIOT/boards/arduino-due/include/periph_conf.h
static const uart_conf_t uart_config[] = {
/* device, rx port, tx port, rx pin, tx pin, mux, PMC bit, IRGn
line */
{(Uart *)UART, PIOA, PIOA, 8, 9, GPIO_MUX_A, ID_UART,
UART_IRQn},
{(Uart *)USART0, PIOA, PIOA, 10, 11, GPIO_MUX_A, ID_USART0,
USART0_IRQn},
{(Uart *)USART1, PIOA, PIOA, 12, 13, GPIO_MUX_A, ID_USART1,
USART1_IRQn},
{(Uart *)USART3, PIOD, PIOD, 4, 5, GPIO_MUX_B, ID_USART3,
USART3_IRQn}
};
I connected Xbee explorers DIN and DOUT pins accordingly to pin number
10 and 11 of arduino.. I also connected 3.3 V pins and gnd pins. I
uploaded Xbee driver test code but it was not working. Initially Xbee
init function was failing while trying to set the address of Xbee.
Please let me know do i need to do anything to run Xbee in Arduino
due. its quite urgent and your quick help is appreciated.
My end goal is to run gnrc_networking / gnrc_border_router with Xbee
Thanks and Regards,
Parul
_______________________________________________
users mailing list
[email protected]
https://lists.riot-os.org/mailman/listinfo/users
_______________________________________________
users mailing list
[email protected]
https://lists.riot-os.org/mailman/listinfo/users
