Hello,
At the end of the SOGo Installation and configuration guide ( version
2.0.7 ), I can read this :
/Upgrading//
//
//This section describes what needs to be done when upgrading to the
current version of SOGo //
//from the previous release.//
//
//2.0.5//
//The confi guration is now stored in /etc/sogo/sogo.conf. Perform the
following commands as //
//root to migrate your previous user defaults://
//install -d -m 750 -o sogo -g sogo /etc/sogo//
//sudo -u sogo sogo-tool dump-defaults > /etc/sogo/sogo.conf//
//chown root:sogo /etc/sogo/sogo.conf//
//chmod 640 /etc/sogo/sogo.conf//
//sudo -u sogo mv ~/GNUstep/Defaults/.GNUstepDefaults \//
// ~/GNUstep/Defaults/GNUstepDefaults.old/
So I think this must be done...
( even if it seems to work without doing anything more )
Regards.
Samuel
Le 31/07/2013 14:48, Christian Mack a écrit :
Hello Rudolf Naujack
Am 2013-07-31 11:49, schrieb Rudolf Naujack:
i'm using SOGo 2.0.5. on Centos5. After updating via yum, must i run
additional scripts?
No.
But there are new options in the SOGo config.
Just read the documentation or the changelogs.
Kind regards,
Christian Mack
--
[email protected]
https://inverse.ca/sogo/lists
