as i follow up, what i did wrong was the fact i just ran 'gmake', and 'gmake install' but it didn't run 'perl Makefile.PL' before that, after I first ran 'perl Makefile.PL' followed by 'gmake', and 'gmake install'everything was fine and URI.pm is copied properly
Op di 15 sep 2026 om 16:32 schreef Bill Cole < [email protected]>: > On 2026-09-14 at 22:26:02 UTC-0400 (Tue, 15 Sep 2026 04:26:02 +0200) > Ruud van den Hout <[email protected]> > is rumored to have said: > > > nevermind, my bad... > > In case anyone else notices this: Mail::SpamAssassin::URI.pm is a new > module that is in the current trunk of the source code repo but which is > not yet in use by any other module. It doesn't install in a 'clean' > build because right now the trunk is not in a release-ready state and > the work which would wire URI.pm into existing SA code to replace > scattered URI-parsing code has not been done yet, along with the simpler > work of making it install. > > Please do not take this as a reason to not install and run the 'trunk' > code or an indication that doing so is in any way discouraged. The trunk > may not always be in a releasable state, but it should always build, > install, and run without major errors. Every bit of code gets reviewed > by humans and tested. > > > > Op ma 14 sep 2026 om 16:17 schreef Ruud van den Hout > > <[email protected] > >> : > > > >> If you build clean from source, the URI.pm is missing from the > >> install (it > >> is in the source directory though) but not copied over after calling: > >> gmake > >> install > >> > > > > -- > Bill Cole > [email protected] or [email protected] > (AKA @[email protected] and many *@billmail.scconsult.com > addresses) > Please keep discussion mailing list replies *on-list* > Not Currently Available For Hire >
