Hello Robin,
Thank you for your answer. I will explain my situation why we want this.
I need to build a OFDM mesh networking setup and we bought several E310
devices due to some size limitations. So, i need to achieve OFDM mesh
network in E310 devices.
Firstly, i tried with embedded CPU but it cannot handle incoming data
rate due to its limited computational capability. When i try RFNoC, just
3 of RFNoC blocks can fit into FPGA and there is no OFDM implementation
with three blocks. So, i guess i need to place some blocks on FPGA and
some blocks on CPU. Is it right? Can you suggest a way to achieve this
task on E310?
On 9.05.2019 09:37, Robin Coxe wrote:
If you need higher BW streaming to a host PC in network mode with a
similar front end to the E310, take a look at the USRP E320 if you
need a 10gigE link or the B210 if USB 3.0 data rates are sufficient.
The E310 was designed to be a standalone embedded SDR, not a networked
device with full BW streaming capabilities.
-Robin
------------------------------------------------------------------------
*From:* USRP-users <usrp-users-boun...@lists.ettus.com> on behalf of
Ramazan Çetin via USRP-users <usrp-users@lists.ettus.com>
*Sent:* Wednesday, May 8, 2019 11:21 PM
*To:* Jason Matusiak; usrp-users@lists.ettus.com
*Subject:* Re: [USRP-users] Running E310 in Network Mode
Hello Jason,
Thank you for your answer. Actually, i have investigated this link.
But, i would like to remove limitations on network mode and use USRP
E310 line USRP N210. Passing samples directly from FPGA to network. Is
it possible?
Regards.
On 8.05.2019 17:14, Jason Matusiak wrote:
See here:
https://files.ettus.com/manual/page_usrp_e3x0.html#e3x0_network_mode
------------------------------------------------------------------------
*From:* USRP-users <usrp-users-boun...@lists.ettus.com> on behalf of
Ramazan Çetin via USRP-users <usrp-users@lists.ettus.com>
*Sent:* Wednesday, May 8, 2019 8:02 AM
*To:* Ettus Research Support; usrp-users@lists.ettus.com
*Subject:* [USRP-users] Running E310 in Network Mode
Hello,
We want to run USRP E310 in network mode. I think the samples coming
from FPGA passing through CPU before sending to network. This decreases
bandwidth because of CPU limitations.
So, is there any ettus image or suggestions that we can run E310
directly from FPGA to network without speed limitations? (like N210
or B210)
Best regards.
Ramazan
_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
