Could you share your flow graph with us? What daughtercards do you have installed?
Sent from my iPhone > On Oct 22, 2019, at 2:16 PM, Richard Bell via USRP-users > <[email protected]> wrote: > > > Hello, > > I'm a little confused about how I should distinguish between two different > USRPs X300's and the two different motherboards per USRP X300 in this type of > setup. I am feeding a 10 MHz ref and PPS ref to both USRPs. What I have right > now is a gr flowgraph with a single USRP Sink block that I have configured > with the following device address > > "addr0=192.168.10.2,addr1=192.168.11.2" > > and I have selected > > Num Mboards = 2 > Num Channels = 2 > > But this setup only uses the addr0=192.168.10.2 USRP to receive on both RFA > and RFB ports. I would like to configure receiving on 192.168.10.2 RFA TX/RX > and 192.168.11.2 RFA TX/RX. > > How do I configure this properly? > _______________________________________________ > USRP-users mailing list > [email protected] > http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com _______________________________________________ USRP-users mailing list [email protected] http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
