Try reducing the gain in the UHD Sink block. At full output, the
waveform will be compressed.
You can also set your Signal Source frequency to zero.
Ron
On 11/15/19 07:05, Van-Dung PHAM wrote:
Dear @Ron,
Thank you for your kindly reply
As you said, I change the frequency to 50MHz-6GHz, and I the
Oscilloscope I got the correct frequency as I want
However, the shape of the signal isn't really sinus. The maximum
sampling rate of my oscilloscope is 5 GSa/s
Do you think the sample rate could change the shape of the sine
waveform? (I set the samp_rate=50MHz)
Best,
Van-Dung
Vào Th 6, 15 thg 11, 2019 vào lúc 13:30 Malik Saad via USRP-users
<[email protected] <mailto:[email protected]>> đã viết:
Dear,
You can change the signal waveform (fro signal source) from sine
to cosine.
On Fri, Nov 15, 2019 at 9:25 PM Ron Economos via USRP-users
<[email protected] <mailto:[email protected]>>
wrote:
You can't have a center frequency of 1 kHz in your UHD Sink
block. The frequency range of the B200 is 50 MHz to 6 GHz.
If you change the center frequency to 50 MHz, you should see a
50.001 MHz signal.
Be sure to terminate the output of the B200 with 50 ohms. With
Gain Type = Normalized, Gain Value = 1 and Amplitude = 1 in
the Signal Source, you'll be transmitting at maximum power.
Ron
On 11/15/19 00:44, Van-Dung PHAM via USRP-users wrote:
Dear all,
I am a newbie in this domain. I want to generate a cosine
waveform in the output of usrp-B200 (TX/RX). So I make it as
the following picture
image.png
But what I got in the oscilloscope is not a cosine/sine
waveform. I don't know where I have a mistake.
Thank you very much for your answers
_______________________________________________
USRP-users mailing list
[email protected] <mailto:[email protected]>
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
_______________________________________________
USRP-users mailing list
[email protected] <mailto:[email protected]>
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
_______________________________________________
USRP-users mailing list
[email protected] <mailto:[email protected]>
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
_______________________________________________
USRP-users mailing list
[email protected]
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
