On 04/29/2021 08:41 AM, Rob Kossler wrote:
Hi Arjan,
I noticed two mistakes in the graph. First, you have 2 radios each
with 1 channel. In your case with only 1 daughterboard populated, I
think it should be 1 radio block with 2 channels. (A radio block is
roughly comparable to a daughterboard). Second, you have the RX
antenna set to "Rx1". This is not valid. It should be "Rx2".
Rob
Actually, the default configuration for TwinRX has RX1 on the first
channel and RX2 on the 2nd channel. If you just leave it at the
default, everything should be fine.
But the point about having a single, two-channel, radio block is the
main issue here.
On Thu, Apr 29, 2021 at 5:49 AM <[email protected]
<mailto:[email protected]>> wrote:
Hi Marcus and thank you,
here is the gnuradio flow-graph and a diagram with the physical setup.
cheers,
Arjan
_______________________________________________
USRP-users mailing list -- [email protected]
<mailto:[email protected]>
To unsubscribe send an email to [email protected]
<mailto:[email protected]>
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
