I was able to re-create the Aurora demo shown at GRCON2019 But it still fails
to initialize about 50% of the time which I haven’t been able to figure out
yet. Any help there is welcome.
Here’s what I did:
I applied the loopback patch found here:
http://ettus.80997.x6.nabble.com/USRP-users-Software-Loopback-RFNoC-TX-RX-same-flowgraph-td16633.html#a16634
Connected the SFP1 ports of two X310’s with an SFP+ Cable, then connected
regular Ethernet from a PC to each of the radios SFP0 ports for control.
I started with the loopback example flowgraph accept I changed the following:
1) In the graph block under device address, addr0=<first radio’s SFP0
address>,addr1=<second radio’s SFP0 address>
e.g addr0=192.168.10.2,addr1=192.168.110.3
2) set ‘device’ parameter on the DDC and RX Radio set to ‘1’
3) set device parameter on DUC and TX Radio were set to ‘0’.
4) skip propagation set to ‘yes’ and Python snippets left the same.
I still have to run the flowgraph several times to get it to work, seems as
though there’s a possible race condition? There’s an RFNOC timeout when it
doesn’t work.
Despite that, I’ve confirmed on an R&S spectrum analyzer that when the
flowgraph runs successfully it passes 160MHz of bandwidth (UBX160
daughterboard) as an RF Relay.
Hope this helps someone.
<end transmission>
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
