I was just asking myself if there is a code to probe the gps. Thanks Regards Isaac T.
El jue, 14 oct 2021 a las 14:51, Marcus D Leech (<[email protected]>) escribió: > Using uhd_usrp_probe is one way. You can also use the sync_to_gps example > which will balk if there isn’t a GPS. > > My recollection is that the PPS light will start blinking once the GPS has > acquired lock. Which can take 10s of minutes from a cold start. > > Sent from my iPhone > > > On Oct 14, 2021, at 2:33 PM, Achilleas Anastasopoulos <[email protected]> > wrote: > > > > > > I have some questions regarding the operation of X310. > > > > 1) How do I know if I have an internal GPSDO (we have 20 USRPs in the > Lab and I remember we bought some of them with GPSDO). I know that when I > do "uhd_usrp_probe", a device without GPSDO says "no internal GPSDO > detected" but in the absence of this message, should I assume there is one > inside? > > > > 2) Upon powering up the USRP and assuming I have an active antenna > connected in the back side (GPS antenna) input, should I expect that at > some point the GPS led (front panel) will start blinking? or do I have to > do something to initiate GPS acquisition? > > > > thanks > > Achilleas > > _______________________________________________ > > USRP-users mailing list -- [email protected] > > To unsubscribe send an email to [email protected] > _______________________________________________ > USRP-users mailing list -- [email protected] > To unsubscribe send an email to [email protected] >
_______________________________________________ USRP-users mailing list -- [email protected] To unsubscribe send an email to [email protected]
