On 2022-08-04 07:59, [email protected] wrote:
Sorry for misunderstanding. I think this is my fault. But as i
mentioned my first question, when i say cable connection, i mean i
connected tx port to rx port with cable. To see the device settings
clearly, i did this. Also, I have b200.
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
Make certain that you have at least 30dB attenuation in that cable.
Otherwise you risk one of two things:
o Severe distortion and non-linearity at the receiver
o Severe damage of the receiver
The power output of an RF amplifier will necessarily vary across its
frequency range. I would expect that over 100MHz to 6GHz
that would be perhaps 5-10dB.
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
