Thanks for your confirmation, Marcus.
On Friday, 12 August 2022 at 14:25:49 BST, Marcus D. Leech
<[email protected]> wrote:
On 2022-08-12 08:49, zhou via USRP-users wrote:
Hi,
I have general question on power control in USRPs. I know the gain range is
from 0dB - 30dB. How is gain control realized, by using active amplifier or
adjusting passive attenuators? Thanks, Hongwei
RF gain control is nearly *ALWAYS* through variable attenuators, and in
USRPs, it's no different.
You can adjust the gain a little on RF amplifiers by playing with bias
voltages, but doing so nearly always
results in other important properties (like linearity and noise figure)
being negatively affected. So, you
optimize the bias to achieve a balance of "good" properties, and then use a
variable attenuator if you
need variable gain.
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
