Hi,
20 and 10dB gain are very low on a B210. See uhd_usrp_probe to see the possible
gain ranges!
Best regards,
Marcus
DISCLAIMER: Any attached Code is provided As Is. It has not been tested or
validated as a product, for use in a deployed application or system, or for use
in hazardous environments. You assume all risks for use of the Code. Use of the
Code is subject to terms of the licenses to the UHD or RFNoC code with which
the Code is used. Standard licenses to UHD and RFNoC can be found
athttps://www.ettus.com/sdr-software/licenses/.
NI will only perform services based on its understanding and condition that the
goods or services (i) are not for the use in the production or development of
any item produced, purchased, or ordered by any entity with a footnote 1
designation in the license requirement column of Supplement No. 4 to Part 744,
U.S. Export Administration Regulations and (ii) such a company is not a party
to the transaction. If our understanding is incorrect, please notify us
immediately because a specific authorization may be required from the U.S.
Commerce Department before the transaction may proceed further.
On 27.02.23 16:27, oiu13q2t5pibtq1--- via USRP-users wrote:
I have 2 B210 with VERT2450s (i.e. 2.4/5 GHz antennae) and compiled uhd from
source
|[INFO] [UHD] linux; Clang version 14.0.0 ; Boost_107400;
UHD_4.4.0.0-0-g5fac246b|
Following the USRP Guide
https://kb.ettus.com/Verifying_the_Operation_of_the_USRP_Using_UHD_and_GNU_Radio, I checked:
|/usr/lib/uhd/examples/benchmark_rate --rx_rate 10e6 --tx_rate 10e6|
on both SDRs
which yielded
|Num received samples: 100243473|
|Num dropped samples: 0|
|Num overruns detected: 0|
|Num transmitted samples: 100064040|
Now I tried to receive signals generated the other via
SDR1: RX:
|/usr/lib/uhd/examples/rx_ascii_art_dft --freq 4996e6 --rate 5e6 --gain 20 --bw 5e6
--ref-lvl -30|
SDR2: TX:
|/usr/lib/uhd/examples/tx_waveforms --freq 4996e6 --rate 5e6 --gain 10|
I would expect a peak somewhere around 4996 MHz; I only see noise which is not affected
by the |tx_waveforms |call
The SDRs are in the same room.
The TX LED is red, the RX2 LED is green, indicating that they are indeed sending and
receiving
Am I missing something important here?!
How can I solve that basic task?
_______________________________________________
USRP-users mailing list --usrp-users@lists.ettus.com
To unsubscribe send an email tousrp-users-le...@lists.ettus.com
_______________________________________________
USRP-users mailing list -- usrp-users@lists.ettus.com
To unsubscribe send an email to usrp-users-le...@lists.ettus.com
