Hi Marcus,
I appreciate you quick responses. They have been useful.
If you look at the code in xport_adapter_ctrl.cpp, specifically
xport_adapter_ctrl::add_remote_ep_route(), you will notice that the dest_udp
is required.I don't think we are getting to the "catch" part, since based on
all the network sniffing, there is not traffic directed to the remote
stream.All the previous messages I sent include the extra "details" at the
bottom of the message.... You can see all the tcpdumps, check for arps, and
specifying a udp_dest.
How does your team (Martin Braun) verify the FPGA is sending data in this
"remote" configuration?
Thanks,--Cy
On Wednesday, May 17, 2023 at 11:11:26 AM PDT, Marcus D. Leech
<[email protected]> wrote:
On 17/05/2023 14:03, [email protected] wrote:
>
> Hi Marcus,
>
> Better news. In an attempt to get my system to match what you might be
> using, a “known” state, I updated the FPGA image.
>
> So the “Requested remote UDP streaming, but transport adapter sfp1
> does not support it!" is gone, and I am at “Device was unable to look
> up Ethernet (MAC) address for IP address 192.168.30.30. Make sure
> device is correctly connected, or provide MAC address manually.”
>
> Again, I saw no arps. Added the mac, it starts up, but I don’t see any
> traffic to 192.168.30.30 using tcpdump, only a trickle of control
> between 192.168.30.1 and 192.168.30.2.
>
> I went back and added all those parameters to my c++ code, with the
> same result, no remote streaming.
>
> How can I demonstrate a KNOWN working version, including the stream
> receiver (in my case 192.168.30.30). What do you use along with
> “remote_rx.py” to validate proper behavior?
>
> Thanks again,
>
> —Cy
>
>
I don't know whether there's a "catchers mitt" client that goes along
with the remote_rx.py example. Since it's a simple
UDP stream, one could use "netcat" and dump the output into a file
for further playing-around. Did you specify the
remote port as well as the address? I don't know what it uses by
default.
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
