Hi, I finally setup a brand new X440. One of the channels appears to be bad. Using the same cable, from the same source, on Ch 2,3 I see a nice sine wave with 1/8 scale amplitude. However, on Ch1 I see a noisy sine wave with about 1/1000 scale amplitude. Since the cable is the same I have to assume the issue is with the port itself.
Is there any way this can be a calibration/SW issue? Using UHD 4.9, rx_samples_to_file. Thanks. Eugene Grayver, Ph.D. Principal Engineer 310-336-1274
_______________________________________________ USRP-users mailing list -- [email protected] To unsubscribe send an email to [email protected]
