Well it depends on what you want Mike.... PCW does do good work with their
finished product just ask Andre. My friend got his 1428 long rod back in a
reasonable amount of time (subjective term). If you want a firm estimate of the
time then you need to consult with PCW directly and be clear on the design and
the time that they will take. My build is a special case and at this point I
want to give them the benefit of the doubt.
I believe in PCW and am holding out hope that I am going to be extremely pleased
in the long run.
so if I discouraged you from pursuing a big bore from them then please disregard
as I was merely surprised by the 1570 post from Rich.
Keep in mind no matter who does the work no one can do this overnight. It takes
months if your lucky.
Take care and if you want further advice reply to me privately.
Take care Phil
Mike wrote:
> Have been saving to have my cylinder block bored and sleeved. Originally, I
> intended to send it off to Madmax, but have not been encouraged by some of
> the postings. Now I'm reading that PCW takes about 1.5 years to finished a
> job if prepaid (I may not be understanding the post on this, it seems like a
> long time), but anyway, my question: Are other shops recommended to do this
> type of work? It seems the local auto machine shops don't want to touch it!
> Thanks to all.
> Mike
>
> .............................................
> To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
> .............................................
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
